Technical Specifications
SPL
110 dB
Amplifier Power
150 W Bass (Class D) + 150 W Treble (Class D)
Frequency Response
38 Hz - 22 kHz ("-6 dB")
Accuracy of Frequency Response
± 1.5 dB (45 Hz - 20 kHz)
Driver Dimensions
⌀ 165 mm Bass + ⌀ 19 mm Treble (view in inches)
Dimensions
H 365 x W 237 x D 223 mm, with Iso-Pod™ (view in inches)
Weight
8.4 kg / 18.5 lb
Connections
1 x XLR Analog Input
1 x XLR AES/EBU Input
1 x XLR AES/EBU Output
2 x RJ45 Control
8340A
SAM™ Studio Monitor
Technical Specifications
Elevate the accuracy of your audio monitoring to a new level with the precision and adaptability of the 8340A Smart Active Monitor.
System Specifications
Frequency Response
45 Hz - 20 kHz (± 1.5 dB)
Low cutoff -6dB
38 Hz
High cutoff -6dB
22 kHz
SPL
Peak SPL
≥118 dB
Maximum peak acoustic output per pair in a listening room with music material at 1 m.
Short term max SPL
≥110 dB
Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m.
Long term max SPL
≥100 dB
Maximum long term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver unit protection circuit) at 1 m.
Self-generated noise
Self-generated noise
≤5 dB SPL
Self generated noise level in free field on axis (A-weighted).
Weight
Weight8.4 kg (18.5 lb)
Dimensions
Height
350 mm
(13 3/4 in)
Height with Iso-Pod
365 mm
(14 3/8 in)
Width
237 mm
(9 3/8 in)
Depth
223 mm
(8 3/4 in)
Enclosure
Enclosure material
Die cast aluminium
Enclosure type
Reflex port
Drivers
Driver type
Cone
Diameter
165 mm
(6 1/2 in)
Driver type
Metal dome
Diameter
19 mm
(3/4 in)
Directivity
Harmonic distortion
> 100 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
3.0 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifier Section
Amplifiers
150 W Class D
150 W Class D
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤1 W
Idle
≤12 W
Full output
180 W
Signal processing section
Connectors
Input
Analog signal input connector XLR female, balanced 10 kOhm.
Input
Digital signal input connector XLR female 110 Ohm.
Output
Digital signal output / Thru connector XLR male 110 Ohm.
2 x Control
Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.
